CatEye CC-MT [Mity 2] • User guide • Download PDF for free and without registration!. Following pdf manuals are available: cat-eye cc-mt mity 2 User Manual. CatEye product manuals for the entire line of CatEye cycle computers, headlights , safety lights and accessories online support at
|Published (Last):||22 January 2013|
|PDF File Size:||2.50 Mb|
|ePub File Size:||18.15 Mb|
|Price:||Free* [*Free Regsitration Required]|
F ATC owner’s manual Battery: If “M” is selected for speed scale, the clock time is in 12 hour. The average speed from start to current point is displayed. Press the “SET” button with a ballpont pen or similar tool.
This manual is cqteye to the following products: With reset operation, it returns to zero. The life of the first factory-loaded battery may be shorter than this period. Maintenance When the main unit or the contact gets wet, dry it off with a cloth; rust will cause functional errors. Press the “SET” button again.
This also turns recording of trip distance and average speed on or off. When the main unit does not receive a signal, or a button has not been pressed for minutes, the power supply is shut down and the main unit will only display the clock. Button Operation Reset Operation Data to be reset: C Mity 8 owner’s manual Battery: Elapsed time is measured from start to current point, in units of hours, minutes and seconds.
C Vectra owner’s manual Battery: When Av or Mx data ccateye shifted to the upper display, Spd shifts to the lower display.
CatEye CC-MT200 [Mity 2] User Manual – Download
These are reset independently, so you can use Trip Distance 2 to record segments within a trip, etc. The wheel calibration number will be displayed with the first two digits flashing.
The calibration number will flicker. Calibration number will appear.
In Tm, Av, Mx, Dst1 and. Push all three buttons at once “SET” button is recessed on bottom of unit.
CatEye CC-MT [Mity 3] User Manual | 4 pages | Original mode | Also for: CC-ED, CC-VL
Accessories Bicycles Parts Specials Tools. C Enduro 2 owner’s manual Mity 3 owner’s manual Battery: It links to owner’s manuals for most cyclecomputers. Continuing Accumulation of Odo Data. Replace it with a new one. Continuously measured until battery wears down. Trip Distance 1, 2. DO NOT use abrasives, sandpaper, etc.
Input wheel circumference A.
CatEye CC-MT [Mity 2] manuals
Then press the “SET” button. If possible, write down the Odo data manyal all clear opera- tion, and input it again after the display returns normal.
Press and hold the “SET” button for 2 seconds to switch back and forth between “A” and “B” calibration value. Press the “MODE” button.
Press S button to change the flickering digit. Mx Maximum Manuap 0. Av moves up as Main Display. This is only a label, the reading is unaffected.